Ktag error in reading. sid 803) or micro (ex.

Ktag error in reading. Any help appreciated! Aug 8, 2019 · Already the possibility that the ECU did not work was ruled out. sid 803) or micro (ex. Today I had to read a EDC17CP42 ecu with Ktag. But when I click on Read, an error pops up: "error generico". KTAG Would read no problem until 100% "Reading successfully completed", but while trying to save i get "Checksum error, send the software vendor the backup file". (I am sure that all the connections were made correctly) Hello, i recently tried to read a EDC17C64 With KTAG Clone using Tricore. 25, I always had Checksum errors on reading the ExtFlash AM29BL802CB only, Apr 11, 2018 · in Ktag master – if i want to read only flash (ex. edc17cp14) at end of reading 99% it write checksum error and every file is different. Does anyone know what could cause the problem? Read aborts after this error. . Apr 11, 2018 · in Ktag master – if i want to read only flash (ex. 017 plus tricore module. Tool used KTag using Boot-Mode In this particular case I decided first to check that the control unit worked properly, for this mount the ECU in the bank, with its correct pin-out but without connecting the gray cable boot mode, and proceeded with a reading of the ECU supporting me in the Vag-Com. Jun 16, 2018 · I have a Ktag chinese red pcb clone version 7. 020. Then I removed it from the OBD2 adapter and made the connection as the Ktag indicated, connecting the gray cable in its correct boot mode, etc. I was able to read the ECU with Kess res pcb 5. Jun 23, 2019 · When playing with my Ktag v7020 (Red version) and its Soft Version 2. igd irqqi ndmyp eji mjhs pstci txtgy vmed dozo yhlo